Toggle Switches LED Turn Signals Kit
This is a 12 volt Toggle Switches LED Turn Signals Kit with surface mount Super Bright D.O.T. approved LED lights (no brackets required). Our toggle switches LED turn signals kit comes with 2 surface mounted ¾” inch amber (front). In addition, 2 surface mounted ¾” inch red (rear) LED lights. However, you can add additional lights to give your street legal UTV or ATV a custom look.
Why Our Turn Signal Kits are Completely Independent
I get asked a few times every month, why don’t you use the UTV or ATV rear OEM lights for the rear turn signals? The answer is very simple. I developed my Turn Signal Kits (TSK) to be completely independent for THREE main reasons. ONE, you do not want any possible feedback from the LED Electronic Flasher into the ECU of your UTV or ATV. Consequently, electronic feedback can cause problems with your ECU and they are very expensive to replace. TWO, you do not want to affect (invalidate) your manufactures warranty by tapping into any existing OEM lights or wiring. THREE, you want both rear stop lights when activating the turn signals (like our automobiles), not just one. As a result, with all my different turn signal kits you will never have these concerns or issues.
TS LED Turn Signals Kit Specifications
This Toggle Switches LED Turn Signals Kit comes with two toggle switches. In addition, 2 LED indicator lights for the Turn Signals and 4-way Emergency Flashers (hazard warning).
The four LED Super Bright Lights are ¾” inch round with an attached rubber grommet for quick mounting. Secondly, they are surface mounted LED’s with a slim-line design for mounting in small spaces (no brackets required). In addition, they meet the P2PC requirements for 45 degree mounting and provide superior light output. Furthermore, they have a Space Saving Design, Hi Impact Acrylic Lens and Housing. Finally, they have Completely Resin Sealed Electronics to eliminate corrosion.
This special LED Flasher has the 3 pin connections for LOAD, PILOT and POWER. Also, the electronic LED flasher is quite, no annoying clicking sounds.
Our Toggle Switches LED Turn Signals Kit includes. 2 Amber and 2 Red SM LED super bright lights with grommets. Secondly, 2 Toggle Switches and 2 LED indicator lights for the turn signals and 4-way emergency flashers. Also, the LED Flasher with mounting hardware. Furthermore, an ATC in-line fuse holder with a 3 amp fuse. In addition, the mounting installation instructions with wiring instructions & diagram. Most importantly, with our Toggle Switches LED Turn Signals Kit you get all the help and support you need from EZ Turn Signal Kits.
Toggle Switches LED Turn Signals Kit Installation
This kit can be easily installed, it does not go into any factory wiring and above all it will not void your manufactures warranty! In addition, each wire has a different color and the wiring diagram shows where each colored wire goes. Above all, I include my phone number and e-mail address with the instructions. Therefore, if you have any questions about your installation you can contact me.
These turn signal toggle switches are very nice and easy to operate. The Motor Vehicle Department and your local police departments will be impressed. Most noteworthy, everyone who rides on the street or off road (dunes/congested areas), should have turn signals for their added safety.
Note: The steering column mounted turn signal switch is the safest and easiest to operate. Most Importantly, we always recommend that you install a steering column mounted turn signal switch kit. To clarify, we recommend our (stock# 104, 105 or 107-SM) on a UTV side-by-side (if you have the steering column space), for your added safety. In other words, a steering column mounted turn signal switch is located in the same area as your automobile. To clarify, it comes natural for activating while keeping your eyes on the road.
The Toggle Switches LED Turn Signals Kit will fit all years and makes for the UTV & ATV models.
In addition you can customize the UTV/ATV with Double or Triple lights. As a result, order from the drop down box Light Options: Double Lights: 4 Amber & 4 Red lights or Triple Lights: 6 Amber & 6 Red lights.
Likewise you may want amber lights front and rear, order from the drop down box Light Options: Amber Kit: All 4 Amber lights or Double Lights All Amber: 8 Amber lights or Triple Lights All Amber: 12 Amber lights
Toggle Switches LED Turn Signals Kit Options
Options: We have some additional LED Lights and a TS Wire & Connector Kit. Therefore, you may want to use these with your Toggle Switches LED Turn Signals Kit. That is to say, any of these options purchased with your toggle switches LED tun signals kit, will save you time & money!
Option1 – Double or Triple Lights for a custom look!
Option2 – TS Wire and Connector Kit, this kit will make it easy to connect your turn signals.
You can order whatever options you want with your Turn Signal Kit by using the drop down (∇) menus above.
Copyright © 2012-2021
Looking for a Horn Kit?
Have you seen the new Polaris models?